28-LED Motorcycle Accent Light Kit Engine & Rear Wheel

All LEDs are pre-wired to a Heat Resistant-Tube Covered Wiring Harness with Cradle Mounts already attached... Just remove your tank, place the 12 LED Harness on your frame over the cylinder heads with the pre-wired Cradle Mounts and place the 8 LED Harness of the Rear Wheel Accent Kit at your Rear Wheel (or anyplace else for that matter) on the right and left side pointing into your rear wheel with the pre-wired Cradle Mounts, And MOST Important  place one POD inside your breather between the two cylinder heads pointing horizontally to the other side then place the other POD on the other side pointing horizontally to the first POD then  connect the Engine Harness, Rear wheel Harness and the two PODs together and connect to your battery... Hit the On/Off Switch and you have the most beautiful LED Accent Lighting you have ever seen... I invented this new system because I got tired of wasting my time crimping and splicing wires... This new system has reduced the time of installation by over 50%. And now it is so simple that anyone can do it... Just place each LED light over your engine where you want them & connect to your battery & you got lights!!! It's that easy!!! This Kit Is Designed To Work On Most Any Bike Made with Two (2) Cylinders Heads...This kit is Not Recommended for "Crotch Rockets"...